2023 Realistic DEA-5TT2 Dumps Exam Tips Test Pdf Exam Material
Powerful DEA-5TT2 PDF Dumps for DEA-5TT2 Questions
NEW QUESTION # 13
In IPv4, what is the proper conversion from binary to decimal for the number 11010010?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 14
What accurately describes OSPF?
- A. Interior gateway distance-vector protocol
- B. Exterior gateway distance-vector protocol
- C. Interior gateway path-vector protocol
- D. Interior gateway link-state protocol
Answer: D
NEW QUESTION # 15
Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?
- A. M6348
- B. M8024-K
- C. MXL
- D. M6220
Answer: C
NEW QUESTION # 16
What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?
- A. 4F:23:AF:4A
- B. 00:C4:4F
- C. 23:AF:4A
- D. 00:C4:4F:23
Answer: B
NEW QUESTION # 17
Which criteria is used to define an extended MAC ACL filter?
- A. Source and destination MAC addresses
- B. Ethernet frame type and frame size
- C. Destination MAC address and Ethernet frame type
- D. Destination TCP port number and source MAC address
Answer: A
NEW QUESTION # 18
Which port type does a Dell EMC Networking N-Series switch have for its console connection?
- A. USB B
- B. RJ-45
- C. USB A
- D. DB9
Answer: D
NEW QUESTION # 19
A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?
- A. Manually specify the OSPF Router ID on each switch within the path.
- B. Break the paths into multiple OSPF areas.
- C. Switch all routing protocols to RIPv2.
- D. Change the reference speed used by OSPF in cost calculations on all switches within the path.
Answer: D
NEW QUESTION # 20
What is the aggregated lanes' maximum speed rating for a QSFP28 transceiver?
- A. 40 Gbps
- B. 128 Gbps
- C. 112 Gbps
- D. 4 Gbps
Answer: C
NEW QUESTION # 21
Which fields are mandatory TLVs in a LLDP PDU frame?
- A. System Capabilities and Management Address
- B. IP Address, Default Gateway, and DNS
- C. Chassis ID, Port ID, and Time-to-Live
- D. Port Description, System Name, and System Description
Answer: C
NEW QUESTION # 22
A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.
Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?
- A. Switch checks its routing table and forwards the packet accordingly.
- B. Switch replies back to the source with an ICMP Reject packet.
- C. Switch drops the packet.
- D. Switch duplicates the packet and sends it to all interfaces.
Answer: A
NEW QUESTION # 23
What are Network Address Translation (NAT) inside global addresses?
- A. Private IP addresses used by the local network
- B. Public IP addresses used by the local network to communicate with the Internet
- C. Addresses used by NAT router when sending frames to devices on the local network
- D. Pubic addresses used by other networks outside of the local network
Answer: B
NEW QUESTION # 24
Which IP address is in the Class B range?
- A. 126.16.20.48
- B. 100.100.90.87
- C. 192.15.48.130
- D. 191.56.44.200
Answer: D
NEW QUESTION # 25
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?
- A. N1700 Series switch and N1500 Series switch
- B. N3500 Series switch and N2000 Series switch
- C. N1500 Series switch and N2000 Series switch
- D. N1700 Series switch and N3500 Series switch
Answer: C
NEW QUESTION # 26
Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?
- A. Cut-through
- B. Fragment-free
- C. Unicast
- D. Store-and-forward
Answer: A
NEW QUESTION # 27
Which IEEE standard defines the Data Link Layer, Discovery protocol?
- A. 802.1AX
- B. 802.1D
- C. 802.1AB
- D. 802.1W
Answer: C
NEW QUESTION # 28
Which port type should be used for only VLAN-unaware devices?
- A. Access port
- B. Trunk port
- C. Hybrid port
- D. General port
Answer: C
NEW QUESTION # 29
What accurately describes the comparison between stacking and VLT?
- A. Stacked switches and VLT peers allow "single pane of glass" management by maintaining a single control plane.
- B. Stacked switches share a common control plane while VLT peers maintain their own control plane.
- C. Both VLT and stacking allow devices to use different versions of firmware provided that the switch family/ series is the same.
- D. VLT allows for more physical devices to appear as one virtual device than stacking does.
Answer: B
NEW QUESTION # 30
If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?
- A. Anycast
- B. Broadcast
- C. Multicast
- D. Unicast
Answer: C
NEW QUESTION # 31
Which field of the 802.3 frame is used by network interface cards to synchronize their receivers?
- A. Cyclic redundancy check
- B. Preamble
- C. Start frame delimiter
- D. Frame check sequence
Answer: B
NEW QUESTION # 32
Which topology is considered a best practice when stacking switches?
- A. Cascade
- B. Ring
- C. Daisy-chain
- D. Serial
Answer: B
NEW QUESTION # 33
Which route type is added to the routing table by a routing protocol?
- A. Directly connected
- B. Default route
- C. Static
- D. Dynamic
Answer: D
NEW QUESTION # 34
A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 35
Which port and protocol is used by NTP to communicate?
- A. TCP port 123 for both the source and destination
- B. UDP port 123 for the source and TCP port 80 for the destination
- C. TCP port 123 for the source and TCP port 80 for the destination
- D. UDP port 123 for both the source and destination
Answer: D
NEW QUESTION # 36
......
EMC DEA-5TT2 (Associate - Networking) Certification Exam is a certification exam that is designed for IT professionals who want to demonstrate their knowledge and skills in networking. DEA-5TT2 exam is offered by Dell EMC, a leading provider of IT solutions and services. DEA-5TT2 exam covers a wide range of topics related to networking, including network design, implementation, maintenance, and troubleshooting.
Guaranteed Accomplishment with Newest Dec-2023 FREE: https://examcertify.passleader.top/EMC/DEA-5TT2-exam-braindumps.html